Congratulations! You're a proud owner of the Antsle! 🎉
Setup is easy! Actually, it’s super easy. Here’s our famous five minute installation process:
Important: Make sure you connect your LAN cable to the correct LAN port on the backside of the Antsle, as depicted.
Connect the other end of the LAN cable to a free LAN port on your router.
Power on your Antsle and allow a few minutes for the boot process.
Go to the antHill activation page. antHill is our portal to set up and configure your Antsle(s).
Input a few details to activate your Antsle
Click "Activate new antsle"
After going through the activation steps your antsle will now show up on your antHill dashboard. Your antsle is now activated!
After you activate your antsle in antHill, you can use your PC or Mac to control your antsle. Anything that has a web browser works (IE and Edge are NOT recommended).
Go to http://<myantslename>.local If you have an antsle.us subdomain use https://<mysubdomain>.antsle.us
Login with username: 'root' and the password you choose in antHill.
Trouble getting the login screen? Try adding port 3000 to the URL: Use http://.local:3000, or if you know the IP address: http://x.x.x.x:3000
Use antMan™ (antlet manager) to create a few antlets.
Go do great things with your private cloud! 🙂
Some exciting videos are next! We invite you to watch our popular FreedomCasts. They will show you in an entertaining manner how easy it is to master some real-life situations with your new Antsle.
Problems? Check our troubleshooting page.
It's also a best practice to configure your IPMI. See below.
The single ethernet port above the two USB ports is a dedicated IPMI port. The IPMI is configured in the BIOS setup of the antsle.
Connect a keyboard and monitor and boot the antsle (this is only required for the initial configuration).
When the antsle begins to boot you will see the Supermicro splash screen. Watch for a message that says 'Press
<del> to enter setup' - then hit
Arrow over to the IPMI menu item.
Select 'BMC network configuration' > 'Configuration Address source' > Static and set the static IP address information.
Hit F4 to Save and Exit
Now you can open a browser and go to http://x.x.x.x (the IP address you set in the bios). The default username/password is ADMIN/ADMIN Go to 'Configuration' > 'Users' to change the password and users for access to the IPMI. For console access, go to 'Remote Control' > 'Console Redirection' > 'Launch Console'
In case you have any questions or comments, please contact us. Don’t hesitate, we’re friendly.